2009 Ford F150 Rear Bumper W1750 Installation Instructions. Overview Congratulations on your new purchase of the industries’ best and most stylish Rear Bumper available for the 2009 Ford F150! This Bumper has been engineered for strength while keeping the weight down. Your Rear Bumper designed in 3-D from digitized data, CNC laser cut, fabricated, and powder coated… all in the U.S.A. Enjoy the fit and finish of a quality Ford F150 Rear Bumper from Fab Fours Inc. II. Tools Required • Socket Wrench with Extension • Breaker Bar • 3/4″ & 18mm Sockets • Flat and Phillips Head Screw Drivers • 3/4″ Box End Wrench • T20 Torx Bit • Floor Jack and wood block. III. Removal of Stock Bumper A. Unplug the Factory License Plate lights from the back side of the light housing from underneath the truck. Turn counter clockwise until loose.
2009 Ford F150 Rear Bumper W1750 Installation Instructions
 |
| 2009 Ford F150 Rear Bumper W1750 Installation Instructions |
Secure up and out of harm’s way. B. Disconnect the wiring harness from the back up sensors. This can either be done by unplugging the connectors at each sensor or removing the sensor from the trim piece holding them into the bumper. C. Remove the 7 plastic Christmas tree plugs holding the harness to the inside of the bumper. Fish the harness out of the bumper and out of the way. D. Remove the 6 bolts (3 per side) holding the factory bumper to the receiver hitch using a 10mm socket. E. Using two people each grasping one corner of the bumper lift and rotate towards the back of the vehicle.
Note the are two plastic locating finger that pass through the hitch that need to be freed for the bumper to come off. F. Your truck is now ready to have the Fab Fours Rear Bumper Installed! IV. Rear Bumper Installation NOTE: The Following Installation steps apply to the installation of the Front Winch Bumper. PLEASE READ THE ENTIRE MANUAL BEFORE ATEMPTING INSTALLATION! Ignoring these steps will increase your probability of scratching the vehicle during product Installation! A. Remove the factory license plate lights from the factory bumper and reinstall them into the Fab Fours bumper. B. Using a small flat head screw driver remove the snap ring on the back of the spare tire lock freeing it from the factory bumper.
Re-install it into the Fab Fours bumper the same way. Installing the supplied zinc plated spacer under the factory snap ring bracket. C. Remove the Driver side bolt plate holding the trailer hitch to the frame using a 21mm socket. Do not remove the passenger side. With the nuts loose pull the hitch away from the frame to grab the retaining washers with pliers to remove. That's information about 2009 Ford F150 Rear Bumper W1750 Installation Instructions hopefully useful.
Re-install it into the Fab Fours bumper the same way. Installing the supplied zinc plated spacer under the factory snap ring bracket. C. Remove the Driver side bolt plate holding the trailer hitch to the frame using a 21mm socket. Do not remove the passenger side. With the nuts loose pull the hitch away from the frame to grab the retaining washers with pliers to remove. That's information about 2009 Ford F150 Rear Bumper W1750 Installation Instructions hopefully useful.
0 komentar: