Honda Goldwing GL1000 Trailer Hitch Installation Procedures
1. Acquire a model-specific trailer hitch kit supposed for use on a Honda Goldwing GL1000. Lay out and establish all the elements by referencing the installation directions supplied with the kit. Raise the motorbike onto its center stand.
2. Use a 5mm hex key to remove the plastic panel between the saddlebags; there are five fasteners holding the panel in place.
3. Fit the left and proper ahead brackets onto the rear crash bar using the supplied nut/bolt/washer assemblies; close the fasteners solely finger tight.
4. Locate the three/eight-inch nuts, the 2 rod end bearings and the 2 trunnion bars. Thread one nut absolutely onto the threads of each rod finish bearing, then thread one meeting into each of the trunnion bars. Don’t totally tighten. Place every meeting, one to every aspect of the Goldwing a thousand, above the exhaust mufflers and inward of the skin line of the motorcycle.
5. Loosely connect the body clamps to the motorbike, installing the smaller clamps around the decrease body bars and the larger clamps around the upper body bars. Set up the subframe plate and use 1/four-inch screws to connect it to the body clamps; turn the screws in solely finger tight. Use three/8-inch screws to connect the trunnion assemblies to the subframe plate; once more, do not fully tighten the fasteners.
6. Connect the rod end bearings to the forward brackets using the mounting bolt and the nylock nut; the bolt needs to be inserted from the underside of the meeting so that the nut is on the top. Use a socket set and wrench to fully tighten all of the fasteners holding the forward brackets in place.
7. Install the eight mounting bolts that hold the subframe plate in place and use a socket set and wrench to completely tighten them. Set up the six bolts that fix the trunnion bars to the subframe plate and use a socket set and wrench to fully tighten them. Install the receiver into the subframe and the tow ball onto the receiver; use the cotter pin to hold the ball in place.
8. Reinstate the plastic panel between the saddlebags using the original hex screws.
0 komentar: