Honda Element Subwoofer Installation Procedures

1. Lift your Honda Aspect’s hood and loosen the bolts that secure each of the battery cables to their respective battery terminals with a ten mm wrench. Carry the negative battery cable from the battery terminal and set it aside. Lift the positive battery cable clamp from the battery. Place the ring terminal from the amplifier wiring package onto the terminal post. Change the positive battery cable clamp onto the terminal and tighten the bolt with the wrench.

Honda Element Subwoofer Installation Procedures

2. Join the facility supply cable from the amp wiring package to the ring terminal. Feed the cable into the passenger cabin by means of the opening within the firewall. Take away the fuse from the ring terminal.

3. Pry the trim panel surrounding the stereo meeting from the dashboard with a trim panel removal tool. Seize the panel, pull it from the dashboard and set it aside. Remove the 4 screws (two on each side) from the stereo bracket with a Phillips head screwdriver. Slide the factory stereo from the dashboard.

4. Disconnect the stereo wiring from the again of the Honda’s stock stereo. Plug the two stereo wiring connectors into the wiring harness adapter leads. Plug the adapter’s lead connectors into the retailers on the again of the stereo.

5. Plug the patch cables into the appropriately marked wiring harness adapter leads. Feed the patch cables via the again of the stereo mounting dock and right down to the floor of the automobile on the passenger’s side. Replace the stereo into the stereo dock and set up the 4 screws across the perimeter of the stereo bracket.

6. Route the power cable from the driver’s side of the Honda to the rear cargo area of the vehicle. Run the patch cables along the passenger’s aspect of the vehicle to the rear cargo area. Place the powered subwoofer behind the Element and join the grounding wire (from the amp wiring equipment) from the sub to a screw or bolt immediately linked to the Honda’s frame.

7. Plug the ability cable into the facility input on the sub. Join the patch cables to the signal and switch-on lead shops on the subwoofer.

8. Substitute the negative battery cable clamp onto the negative battery terminal post. Tighten the cable’s clamp to the terminal with the wrench. Place the fuse back into the fuse holder on the ring terminal and close the hood.